Facebook
Jan.2020 10
Views: 664
Teach You How To Change The Oil Filter
Introduction
Vehicles should be regularly changed oil to ensure that the indicators are within acceptable limits. Regularly changing the oil of the vehicle is the top priority of car maintenance. How often should I change the oil filter?
Details

Vehicles should be regularly changed oil to ensure that the indicators are within acceptable limits. Regularly changing the oil of the vehicle is the top priority of car maintenance. How often should I change the oil filter? How to change the oil and oil filter correctly? The following Durable Hydraulic Oil Filter Supplier has organized related strategies for you.
 

First, changing the oil is a day job. When changing the oil, be sure to follow the requirements of the user manual. The specific process can refer to the following steps.
 

Required tools:

1. A new Oil Filter: Most vehicles use rotating oil filters of different models and sizes.

2. Machine filter spanner: This is a necessary tool when changing machine filters.

3. Gloves: This cotton thread gloves on the picture. Wear gloves first to prevent slipping and second to prevent burns.

4. Oil basin: It must be used to prevent the oil from flowing everywhere. Suggestion: Put a plastic bag on the basin again, it is more convenient to dispose the waste engine oil, and it can also make the basin a little cleaner.

5. A funnel and a wooden wedge.

6. Jack: bring it when you lift the car.

7. Spanner

Oil Filter
 

Oil Filter
 

Replacement steps
 

The first step, vehicle preparation. Run the engine to the operating temperature. Then use a jack to lift the vehicle, pull up the handbrake and squeeze the front wheels with wooden wedges. Drill into the chassis to see what's happening (note that you must first understand the special safety precautions mentioned in your user manual).

The second step, drain the old oil. Use a spanner to loosen the oil plug screw counterclockwise. Don't overdo it. At this time, put the pot with the plastic bag under the screws (slightly back. Prevent the oil from spraying when the oil is just out.) After putting the pot, continue to screw the screws by hand until the When dripping oil, be careful to unscrew the screws. Do not get burned by hot oil. (Recommended for maintenance when cooling the car.)

The third step is to remove the oil filter. When the oil flow is about the same, you can use the machine filter spanner to remove the filter, open the oil cover on the engine cover, and use the filter spanner to loosen the oil filter counterclockwise. Unscrew the oil filter from the engine compartment, taking care not to touch the hot exhaust manifold. There is still a little residual oil in the machine filter at this time. Be careful not to drip everywhere.

The fourth step is to fill with new oil. Above the engine, you will see a cap with the word "oil" on it. Open the oil cap, insert the funnel and fill in a certain amount of oil, and pull out the dipstick to determine whether it is full. Then cover the oil cap and wipe off the spilled oil.
 

The fifth step is to start the engine for a few minutes. Then close and check the dipstick again to determine if the oil level is appropriate. Finally, see if there is any oil leakage from the bottom of the vehicle.
 

The sixth step is to dispose of used oil. Do you think this is all right? Not yet! Finally, in terms of safety and environmental protection, this is the most important step, which is to properly dispose of used oil or waste oil from vehicles. Waste oil is very toxic to the environment, so it is extremely important to handle waste oil safely. It is suggested that you can put the waste oil in a sealed container and consult your local auto repair shop for safe disposal methods. It is possible that a car repair shop near you can recover these waste oil and recycle them or recycle them safely.
 

The above is the method of replacing the oil filter introduced by the Hydraulic Oil Filter supplier. I hope it can help everyone.